However, the Texas instruments CC3000 WiFi Chip/Module that is utilized the Sparkcore only implements a very rudimentary subset of multicast DNS (mDNS). I did some quick and admittedly sloppy research and I believe based on this Sparkcore Forum post that the Oscuino library has been successfully ported to also run on the Sparkcore. This should also work nicely with a Sparkcore. It may be possible to get this to work, but I have decided to use my limited time for something else 😉 Installing Avahi – the Linux implementation of ZeroConf Networking requires more memory than these small routers have. Open-WRT is Linux based and does not support Bonjour out-of-the-box.
This only works with these two little routers with the original firmware. I’ve persevered through the Chinese and have worked successfully with the 703n as well as the 702n.Ī note of caution: In the section below “What’s left to do” I mention that this setup also can be made work nicely in conjunction with Apple’s Bonjour. However, out-of-the-box the interface is in Chinese.
#Touchosc editor tutorial software
The TL-WR703n that is also available cheaply on eBay has a more capable processor and is popular amongst people that want to run the Linux based Open-WRT router software on the little router. The web interface that is used to configure these routers is in English. If a WiFi solution is desired the simplest solution is to connect a little pocket WiFi router such as the TP-Link TL-WR702n or TL-MR3020 to the Ethernet shield or module. This has been tested with an original Arduino Ethernet Shield on an Arduino Uno and with the WIZ820io Ethernet Module in conjunction with a Teensy 3 The Seeed Studio Ethernet Shield V2.0 for example hosts the W5200 Ethernet Chip and comes with it’s own version of the Ethernet Library that supports the W5200 chip. A word of caution: the standard Arduino Ethernet library does not support the W5200 Ethernet Chip so if you want to use a clone with a W5200, make sure it’s supported with a version of the Ethernet library. As long as these host a W5100 or W5200 Ethernet chip it should work. There are several clones of the original shield available in different price ranges. This was tested with an Arduino Uno, and a Teensy 3
#Touchosc editor tutorial how to
This little tutorial describes how to control an Arduino with TouchOSC.
0 kommentar(er)
